Removal

1 For improved access, firmly apply the handbrake, then jack up the front of the car and support it securely on axle stands.
2 Undo the two screws each side securing the edge of the Fiat Punto bumper to the wheel arch liner (see illustrations).



Undo the upper screw (arrowed) …



… and lower screw (arrowed) each side, securing the edge of the bumper to the wheel arch liner


3 Undo the two bolts securing the upper edge of the bumper to the front wing on each side. Reach up behind the wheel arch liner to gain access to the front bolt (see illustrations).



Undo the two bolts each side securing the upper edge of the Fiat Punto bumper in the front wing ...



... reaching up behind the wheel arch liner to access the front bolt (arrowed)


4 From below, undo the bolt securing the bumper lower outer edge to the crossmember on each side.
5 Undo the two centre bolts securing the front underside of the bumper to the crossmember (see illustration).



Undo the two bolts (arrowed) securing the front underside of the bumper to the crossmember


6 Support the bumper, then undo the remaining two bolts from the upper edge of the bumper (see illustration).



Undo the remaining two bolts (arrowed) from the upper edge of the bumper


7 Where applicable, unplug the wiring from the rear of the foglight units.
8 Unclip any electrical cabling secured to the rear side of the bumper then, with the help of assistant, carefully draw the bumper away torn the front of the car (see illustration).



Carefully withdraw the Fiat Punto bumper from the car


Refitting

9 Refining is a reversal of removal.